Sledgehammer Enthusiast
|
That epoxy center can pe punched out. I used a piece of re-bar and hammer clamped the piece and it came out in a few "hard" swings
Don't forget about the 15 lb chunk of #1 steel on the inside its 2" thick. I think the fastest way would be to cut all around one side and pull it off from the other either way the plastic is messy
edit: i would check the wires before even starting i have gotten one with ali
Last edited by NHscrapman; 06-23-2013 at 05:42 AM.
There ain't nothing wrong with an honest days work. Anyone who says otherwise is a fool.- Old Man
There are currently 1 users browsing this thread. (0 members and 1 guests)
|
Browse the Most Recent Threads
On SMF In THIS CATEGORY. 
OR 
|
Posting Permissions
Bookmarks