On the cheap you can put a board in a vice or other type holding device. Drill a hole a little larger than the wire you want to strip. Sharpen the point of a drywall/deck screw and screw it into the board so the tip enters the side of the hole you drilled.
Now insert the wire a little bit, tighten the drywall/deck screw until it pierces the plastic of the wire. Use some pliers to pull the wire through the hole in the board. Cheap and adjustable.
Personally I vote for selling the wire as is and use the extra time finding more stuff to scrap or read more of the forum for more ideas. 73, Mike
Bookmarks