Im not sure if I can explain my stripper and I have yet to figure out how to post pics. So here goes. I took plumbing flairing tool. Square bar with various size holes for different sizes of tubing. I removed everything from the tool so it's just the block. There are two bolts at each end that allow you to separate the 2 halves of the block. What I do is pic a hole about the size of my wire then place a box knife razor blade in it and adjust the blade so that it will cut through the shielding. Now I place the tool in my bench vice then from the back side press your wire in till it clears the blade. Now just pull the wire through. It's stupid simple and works great for all the wires I strip. Only thing that takes a little extra time is I presort my wire into similar gauges so that im not adjusting the blade more than I need to. Man I wish I could figure out how to post pics.