neat heat sink

Originally Posted by spinroch

Bifurcated! I love that word!
You can cut the aluminum with an angle grinder (Use a vice, Gloves & goggles!)
The copper can then be easily driven out.
I usually set them across a couple of transformers (for support) and use a hammer and a big punch. Then I blast the copper slug out.
Then it turns into money!
Make sure you do this on a concrete floor and not on your workbench, if you can.

I put the aluminum part in a vice and use a grinder to cut the part holding the copper. Then it pops out easy. Otherwise, I could beat on that copper slug forever and it was so tight, it wouldn't budge.