Results 1 to 20 of 60

Threaded View

  1. #35
    armygreywolf started this thread.
    armygreywolf's Avatar
    SMF Badges of Honor




    Member since
    Dec 2013
    Location
    Germantown, WI
    Posts
    1,085
    Thanks
    193
    Thanked 2,059 Times in 646 Posts
    I'm a processing monster...probably the fastest dismantler on the forum. BUT caveat here, the right tools, the right workbench and the right help. At some point when I'm not hair pulling, eye bleeding busy I will do ten PSUs for a youtube video. Likewise I will do ten towers, ten optical drives, ten hard drives and I hope this will maximize the labor involved. Speed is the one reason I can pay more for PSUs and things of that nature than anyone in my area. And FLimits, I pay 23 cents without wire. with is 33 to 34.

    Fast enough I can just about beat the charger for the tool I'm using, a Bosch 12V Li-Ion 1/4 hex drive and a 3/8" drill/driver of the same model.

    Big emphasis on the right tools, you need a light cordless that has a fast speed with a "tip in" which means it doesn't apply immediate full speed it increases over a 1/4 second or so which is just enough not to strip those little screws. Also, I use two tools rather than swapping out bits (especially hard drives where I need a T8 and T7) I reviewed the bosch in the tools section.


  2. The Following 6 Users say Thank You for This Post by armygreywolf:


Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

 
Browse the Most Recent Threads
On SMF In THIS CATEGORY.





OR

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

The Scrap Metal Forum

    The Scrap Metal Forum is the #1 scrap metal recycling community in the world. Here we talk about the scrap metal business, making money, where we connect with other scrappers, scrap yards and more.

SMF on Facebook and Twitter

Twitter Facebook