Page 1 of 2 12 LastLast
Results 1 to 20 of 25

Gold Plated Circuit Board?

| General Electronics Recycling
  1. #1
    CMHN started this thread.
    CMHN's Avatar
    SMF Badges of Honor


    Member since
    Jul 2011
    Location
    Berwick, Pa
    Posts
    380
    Thanks
    49
    Thanked 339 Times in 111 Posts

    Gold Plated Circuit Board?

    Im not a big E-Waste guy, I mainly deal with shred. When I come accross items that need to be broke down further to get aluminum, brass, copper or stainless out I will put them in a pile. When I get bored I will go thru the pile and break the items down. Today was one of those days.

    I was breaking down an item and saw a circuit board in it and thought "another low grade board" but when I got it out it looks to have a lot of gold on it.

    The front is nice enough, but check out the back.

    I am thinking it is gold because the item that it was taken out of spends its entire life outside in the elements and gold will not tarnish or corrode. I could be wrong but that is my way of thinking.

    What do you think?





    CMHN Recycling


  2. #2
    SMF Badges of Honor


    Member since
    Nov 2011
    Location
    boise, ID
    Posts
    1,605
    Thanks
    469
    Thanked 1,462 Times in 668 Posts
    Did it come out of a keypad of some sort?

  3. #3
    CMHN started this thread.
    CMHN's Avatar
    SMF Badges of Honor


    Member since
    Jul 2011
    Location
    Berwick, Pa
    Posts
    380
    Thanks
    49
    Thanked 339 Times in 111 Posts
    So I was curious if the first one was a fluke or if other makers have the same kind of board, well looks like they all have the same kind of board.





    I have some reservations disclosing where these are coming out of because these items are everywhere and it would be very easy for the "scrap thieves" to have a field day. I know that most of the active members on this forum aren't thieves, but we have lurkers and general public that come here looking for the quick buck and don't care who they hurt getting it.

  4. The Following 6 Users say Thank You for This Post by CMHN:


  5. #4
    Otto's Avatar
    SMF Badges of Honor


    Member since
    Nov 2011
    Location
    Ottawa, Ontario
    Posts
    335
    Thanks
    494
    Thanked 322 Times in 166 Posts
    Might just be my monitor, but the colour looks more like copper than gold to me.

  6. #5
    CMHN started this thread.
    CMHN's Avatar
    SMF Badges of Honor


    Member since
    Jul 2011
    Location
    Berwick, Pa
    Posts
    380
    Thanks
    49
    Thanked 339 Times in 111 Posts
    No, its my pictures, believe me they are gold in color not copper.

  7. #6
    SMF Badges of Honor


    Member since
    Nov 2011
    Location
    boise, ID
    Posts
    1,605
    Thanks
    469
    Thanked 1,462 Times in 668 Posts
    I just checked mine and it was gold too.

  8. #7
    Scrap man's Avatar
    SMF Badges of Honor

    Member since
    Nov 2010
    Location
    NY
    Posts
    657
    Thanks
    36
    Thanked 172 Times in 93 Posts
    Quote Originally Posted by CMHN View Post
    I have some reservations disclosing where these are coming out of because these items are everywhere and it would be very easy for the "scrap thieves" to have a field day. I know that most of the active members on this forum aren't thieves, but we have lurkers and general public that come here looking for the quick buck and don't care who they hurt getting it.
    That's like saying "I know where there's a ton of money laying around!... But I'm not telling you" I'm personally dying from curiosity and would love to know where they came from. I wouldn't worry about someone stealing them
    There's nothing more fun and more effective than hitting something repeatedly with a sledgehammer

  9. #8
    SMF Badges of Honor

    Member since
    Oct 2011
    Location
    Lancaster NH
    Posts
    331
    Thanks
    13
    Thanked 178 Times in 104 Posts
    have a gold testing kit?

  10. #9
    SMF Badges of Honor


    Member since
    May 2011
    Posts
    187
    Thanks
    63
    Thanked 62 Times in 22 Posts
    CHMN , I have one of those myself! I hope it's Gold!

  11. #10
    PartTimeScrapper's Avatar
    SMF Badges of Honor



    Member since
    Aug 2011
    Location
    Morrison, Colorado
    Posts
    3,400
    Thanks
    1,004
    Thanked 3,256 Times in 1,335 Posts
    ok now I want to know what they are from Come on you know you want to tell us.

  12. #11
    SMF Badges of Honor


    Member since
    Nov 2010
    Location
    Boise, ID
    Posts
    2,702
    Thanks
    2,237
    Thanked 2,352 Times in 1,014 Posts
    Almost looks like a keyless door entry.

  13. #12
    PartTimeScrapper's Avatar
    SMF Badges of Honor



    Member since
    Aug 2011
    Location
    Morrison, Colorado
    Posts
    3,400
    Thanks
    1,004
    Thanked 3,256 Times in 1,335 Posts
    Ahh like the genie pads that hang outside of garages Thats it im going around my neighborhood right now and ripping every single one of them off the wall. Where is my hatchet?

  14. The Following 5 Users say Thank You for This Post by PartTimeScrapper:


  15. #13
    SMF Badges of Honor


    Member since
    Nov 2010
    Location
    Boise, ID
    Posts
    2,702
    Thanks
    2,237
    Thanked 2,352 Times in 1,014 Posts
    Not sure if garage door key pads have much in them. Tore apart one once. Had a green board and a few wires.

    The one I am talking about you see them on hotel doors, homes, etc.


  16. #14
    PartTimeScrapper's Avatar
    SMF Badges of Honor



    Member since
    Aug 2011
    Location
    Morrison, Colorado
    Posts
    3,400
    Thanks
    1,004
    Thanked 3,256 Times in 1,335 Posts
    ok well then in that case im going downtown denver to one of the highrise hotels and ripping every single card reader door thingie I can fine Hey KZ keep your cellphone on you I may need bailed out of jail in the AM.

  17. The Following 3 Users say Thank You for This Post by PartTimeScrapper:


  18. #15
    KzScrapper's Avatar
    SMF Badges of Honor


    Member since
    Apr 2011
    Location
    Denver Metro, CO
    Posts
    4,841
    Thanks
    7,019
    Thanked 5,792 Times in 2,417 Posts
    Between this and the power poles I'm sure you'll be in stripes by noon.
    Recyclable Material Merchant Wholesaler
    Certified Zip-Tie Mechanic
    "Give them enough so they can do something with it, but not too much that they won't do nothing."

  19. #16
    injunjoe's Avatar
    SMF Badges of Honor



    Member since
    Jan 2011
    Location
    Central, FL
    Posts
    1,309
    Thanks
    1,249
    Thanked 1,194 Times in 594 Posts
    Quote Originally Posted by IdahoScrapper View Post
    Not sure if garage door key pads have much in them.
    Not much in them! If there was I would be rich!
    When the white man discovered this country Indians were running it
    no taxes, no debt, women did all the work.
    White man thought he could improve on a system like this. - Old Cherokee saying

    I did not surrender, they took my horse and made him surrender. - Lone Watie

  20. #17
    SMF Badges of Honor


    Member since
    Nov 2010
    Location
    Boise, ID
    Posts
    2,702
    Thanks
    2,237
    Thanked 2,352 Times in 1,014 Posts
    Quote Originally Posted by PartTimeScrapper View Post
    ok well then in that case im going downtown denver to one of the highrise hotels and ripping every single card reader door thingie I can fine
    haha. CMHN said it's in an item that is outside for the duration of its life.

    I am still curious. Wonder if he would post to the scrap room?

  21. The Following User Says Thank You to IdahoScrapper for This Post:


  22. #18
    Dumpster-Dee's Avatar
    SMF Badges of Honor



    Member since
    Feb 2011
    Location
    SW Georgia
    Posts
    1,775
    Thanks
    2,286
    Thanked 838 Times in 457 Posts
    try water meters PTS....get some on your route.

  23. #19
    SMF Badges of Honor


    Member since
    Dec 2011
    Location
    Port St Lucie, FL
    Posts
    176
    Thanks
    128
    Thanked 58 Times in 35 Posts
    What about this circuit board?



    LOL - Okay just had to list this since I came across it while I was research gold plated circuit boards... LOL
    If you like to Scrap the Crap & Cash the Trash - Then Check out our Videos on Youtube!

  24. #20
    KzScrapper's Avatar
    SMF Badges of Honor


    Member since
    Apr 2011
    Location
    Denver Metro, CO
    Posts
    4,841
    Thanks
    7,019
    Thanked 5,792 Times in 2,417 Posts
    Not going to reply to the above with a quote cuz you shouldn't have to look at that again...

    If people keep posting photos like this, pics of Daisy and Bret are going to have to become a sticky so we can get the sting out of the eyeballs as needed.

  25. The Following 4 Users say Thank You for This Post by KzScrapper:



  26. Similar threads on the Scrap Metal Forum

    1. board trimmings gold fingers / solid plated
      By jghilino in forum Computer Recycling
      Replies: 18
      Last Post: 06-02-2013, 12:51 PM
    2. Gold trace circuit board
      By Abuilder in forum General Electronics Recycling
      Replies: 10
      Last Post: 05-10-2012, 01:09 AM
    3. Non computer circuit board values
      By alperin in forum General Electronics Recycling
      Replies: 21
      Last Post: 09-29-2011, 06:51 PM

Page 1 of 2 12 LastLast

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

 
Browse the Most Recent Threads
On SMF In THIS CATEGORY.





OR

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

The Scrap Metal Forum

    The Scrap Metal Forum is the #1 scrap metal recycling community in the world. Here we talk about the scrap metal business, making money, where we connect with other scrappers, scrap yards and more.

SMF on Facebook and Twitter

Twitter Facebook