Search:

Hi There,

used the search and couldn't come up with an answer. Do you need to remove the metal brackets on the gold finger cards before sending them in to ewasted?

Thanks

Would love to find a local buyer paying good prices on boards/cards. No Luck So Far! $3.25 is the highest quote on motherboards.

Al Extrusion - .65
Cu - Al Mix. - 1.15
Shred .10lb
Insulated Cu wire (power cords, etc) 1.05

How do you want the boards and cards prepared? Do you require the heatsinks and metal brackets taken off of the gold finger cards (Video card, Etc)? I've never sold to a buyer off of here but...

I've been self employed since about 1998 - A set schedule is the key. When I look back at the not so good times. I was doing whatever, whenever I felt it needed to be done. When times are good its...

I pretty much did the same thing. "I can do this, I a little bit of a chemistry background" Then researched and decided it would be to much of a headache. If I want the metals refined, Ill save up...

I have been selling on ebay for over 14 years now. Used to do a lot of consignments @25% but those days are long gone. Now with the higher fees, Free shipping, frequent charge backs. It makes it...

Just under $800, sold a few boxes of motherboards that were collecting dust.

I have been scrapping most any hard drive 30GB and Under. There are some 8GB and less that have some value as "Vintage" You just have to check part numbers.

The vertical lines could be a bad onboard video. If you have another hard drive, try installing it and mac os again and see if runs normally.

I've been removing all the heasinks... On both the motherboards and video cards. The local buyer hear was complaining about them. Might have to try one of the buyers hear soon!

Thanks for the welcomes. I'm in the Tacoma/Puyallup Area.

I have bought quite a few pallets of these over the years, Unless the 2005 are quad G5, and the 2006's are actually Mac Pros (They look the same at first glance) WAAAAY over paid, even for parts.

Just wanted to say hello, Looking to maximize the scrap computer equipment I end up with. Been buying pallets for years and sometimes just need a few pieces off of them. Now with the economy and...