Results 1 to 2 of 2

Suggestions To Remove Connectors?

| Scrap Metal Tips and Advice
  1. #1
    BKG started this thread.
    BKG's Avatar
    SMF Badges of Honor

    Member since
    Sep 2015
    Location
    Texas
    Posts
    4
    Thanks
    0
    Thanked 0 Times in 0 Posts

    Suggestions To Remove Connectors?

    Hello all...Trying to figure out an easy way to remove the connectors on an 8-way coaxial splitter. The connectors are brass and the casing is aluminum.

    Here's a link of what I'm talking about. (Regret link, can't attach picture).

    DIRECTV 8-Way Wideband Splitter for SWM Satellite LNBs (SPLIT8MRV) from Solid Signal

    The connectors are threaded, so it's possible to screw them off but trying to figure out if there's a tool that I can do this quickly & efficiently. I have a few hundred of these so if I can do quickly & efficiently, it might be worth it to separate.



    Any suggestions would be helpful.


  2. #2
    Patriot76's Avatar
    SMF Badges of Honor


    Member since
    Dec 2012
    Location
    Buffalo Commons
    Posts
    2,949
    Thanks
    10,589
    Thanked 7,220 Times in 2,256 Posts
    Hammer, hatchet, linesman plyers, and nut driver and Philips screw driver attached to an impact driver or drill. Advantage using cordless. I use one bit on the impact driver and the other on the drill.
    Give back more to this world than we take.

  3. The Following User Says Thank You to Patriot76 for This Post:



  4. Similar threads on the Scrap Metal Forum

    1. Looking for suggestions on lot of SSD
      By agesurplus in forum General Electronics Recycling
      Replies: 14
      Last Post: 06-20-2015, 01:58 PM
    2. To remove or not to remove...that is the question.
      By cmgscrap in forum E-Waste Grading and Identification
      Replies: 14
      Last Post: 03-09-2014, 09:08 PM
    3. Demo saw suggestions
      By MetalEarthRecycling in forum Tools and Equipment
      Replies: 4
      Last Post: 06-17-2013, 11:36 AM
    4. Ballmill, Suggestions?
      By injunjoe in forum Tools and Equipment
      Replies: 38
      Last Post: 06-09-2012, 10:58 AM
    5. sitename suggestions
      By GeorgeB in forum Off Topic Discussions
      Replies: 83
      Last Post: 12-31-2011, 10:22 PM

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

 
Browse the Most Recent Threads
On SMF In THIS CATEGORY.





OR

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

The Scrap Metal Forum

    The Scrap Metal Forum is the #1 scrap metal recycling community in the world. Here we talk about the scrap metal business, making money, where we connect with other scrappers, scrap yards and more.

SMF on Facebook and Twitter

Twitter Facebook