Results 1 to 3 of 3

info for newbies - Rare earth magnets

| Scrap Metal Tips and Advice
  1. #1
    BubbaLugnut started this thread.
    BubbaLugnut's Avatar
    SMF Badges of Honor

    Member since
    Nov 2014
    Location
    Lugoff, SC, USA
    Posts
    3
    Thanks
    4
    Thanked 6 Times in 2 Posts

    Exclamation info for newbies - Rare earth magnets

    Have been a magnet freak most of my life, even b4 starting in scrapping. Have found that Rare earth magnets (neodymium) have the best "pull". If you can't find any in your scrappings, you can find them online fairly cheap. Very useful investment. I have some smaller ones, rated N42 that will pick up a vitamin pill, cuz it attracts the iron in the vitamin. Some large fridge mags have a plastic casing, which makes them easier to remove and also protects them as they are very brittle. Rare earths do not tolerate high temps well, as they start to lose magnetism above about 175 deg. F and completely demagnetize around 500 deg. F. Be careful not to drop them on the ground as they will find every piece of rust or shaving that is nearby! If this happens, they can be cleaned fairly well with a sharp blast of air from your compressor.


  2. The Following 3 Users say Thank You for This Post by BubbaLugnut:



  3. #2
    diggydiggy's Avatar
    SMF Badges of Honor


    Member since
    Jul 2014
    Location
    Columbus, Ohio
    Posts
    50
    Thanks
    26
    Thanked 45 Times in 21 Posts
    I like playing with the neodymium magnets but I don't use them to identify scrap. They will normally attract stainless and some aluminums, also can pick up some brass. I like using the magnets from microwave magnetrons. Never in short supply, I keep one on the back of the truck and back of the trailer too. Also keep one in the cab behind the seat, stuck to the cab.

    Mike

  4. #3
    eesakiwi's Avatar
    SMF Badges of Honor



    Member since
    Dec 2010
    Location
    NZ
    Posts
    2,531
    Thanks
    2,909
    Thanked 2,556 Times in 1,227 Posts
    I like using the microwave magnets to test metals. Their 'feild' seems to extend furthur than the hard drive magnets.
    They are easyer to pick up and hold & break into peices.

    When i ws scrapping out of partly crushed cars at a ex wreckers i would put 2 or 3 into the bottom of a 2 litre icecream container (plastic) and sit another into the first one, then put mu sockets etc into the top one.
    They would stay in there and the container would stick to the roof etc of the cars & not move.

    Also, because they were stacked up to 4 high, I would have a couple in my front pockets, I could stand on one cars windowsill and work on the car above and the magnets would stick to anything metal and hold my balance.....
    Not recommended as 'safe' though. I thought it was funny, stuck like a fly to a car..

  5. The Following User Says Thank You to eesakiwi for This Post:



  6. Similar threads on the Scrap Metal Forum

    1. National - Accurate Recycling, We buy what scrap yards don't | Rare-Earth, Refractory & Precious
      By JosephLeo in forum Scrap Buyers & Sellers
      Replies: 35
      Last Post: 07-02-2019, 09:19 PM
    2. Rare HP Motherboard?
      By zaige1982 in forum Scrap Metal Tips and Advice
      Replies: 10
      Last Post: 10-28-2013, 12:49 PM
    3. Newbies First Day Results
      By Mabrito88 in forum A Day in the Life of a Scrapper
      Replies: 27
      Last Post: 07-20-2013, 09:20 PM
    4. A rare opportunity
      By crowbar in forum Dismantling, Breaking Down & Maximizing Scrap
      Replies: 13
      Last Post: 08-13-2012, 06:27 AM
    5. newbies, met one yesterday
      By corycouch in forum A Day in the Life of a Scrapper
      Replies: 20
      Last Post: 07-13-2012, 09:32 PM

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

 
Browse the Most Recent Threads
On SMF In THIS CATEGORY.





OR

Tags for this Thread

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

The Scrap Metal Forum

    The Scrap Metal Forum is the #1 scrap metal recycling community in the world. Here we talk about the scrap metal business, making money, where we connect with other scrappers, scrap yards and more.

SMF on Facebook and Twitter

Twitter Facebook