Printable View
First, i have done a few searches, but couldnt find what im looking for. I have the two drums out. I have the agitator shaft un bolted (5 or 6 around shaft, and then two acting as a clamp.) I took out all the gears. So depending on how you look at it (washer standing up in normal position) i need to remove the top half of the tranny.
on a side note, i found less than $1 in change, but possible one diamond earing and one pearl one :)
If memory serves me, the Maytag washer has a wicked spring coiled up inside a spool. This spring released unexpectedly can injure you seriously.Quote:
Originally Posted by dryvr12
Perhaps one of our appliance technicians could shed some light on this possible danger.
if i pull on the tranny, it comes out about 3/4 of an inch, but then goes back in. i reallywant to keep the outside drum, and would rather not cut it if i dont have to.
How about a picture, there are a few different ways they are attached.
I got it off. just had to hit it with a hammer a few times :p
BFH FTW Gotta love brute force.
yeah i posted late last night and didnt wanna be a d*** to the neighbors. but got it off in about 5 min after school. go figure -_-