Looking at buying a copper wire granulator Wanting to spend around 50000. Was thinking about a Strip tech. Or a one from Guidetti . Or one from Cable management. Was wondering if any one any advice. On any of them or experience. Good or bad.
Printable View
Looking at buying a copper wire granulator Wanting to spend around 50000. Was thinking about a Strip tech. Or a one from Guidetti . Or one from Cable management. Was wondering if any one any advice. On any of them or experience. Good or bad.
This is a previous thread about the subject. I do not know anything about them, but this might give you some ideas.
https://www.scrapmetalforum.com/tool...ranulator.html
I seen that thread. From three years ago . I figure the technology has change a lot since then . I also knew High Voltage Processing had went out of business . Was wanting a fresh take on it. Also with China National Sword campaign starting to kick in . Was wondering how it would effect insulated copper wire .
I know must yards bale their lower grade wire and ship it overseas. But I figure that with China National Sword Campaign starting. That might change . Most of the higher grade are done here in the USA. But if China crack down . Even the higher grade prices will go down due to lack of competition.