All prices are per lb.
#1 copper 1.75
#2 " 1.60
Al U minium
Cast .20
Sheet .30
Extru .35
6063 .30
Aircraft grade. To be assessed
Insulated wire. .35 to .95
Electric motors .12
Shed, minimum of 300 lbs > 2.5 cents/lb
CRT monitors .08
Brown boards .05
Printable View
All prices are per lb.
#1 copper 1.75
#2 " 1.60
Al U minium
Cast .20
Sheet .30
Extru .35
6063 .30
Aircraft grade. To be assessed
Insulated wire. .35 to .95
Electric motors .12
Shed, minimum of 300 lbs > 2.5 cents/lb
CRT monitors .08
Brown boards .05
.50 a pound for brown boards is really good actually....and some actually PAYING for CRT's...HOLY FRIGGIN #$%^!!
The rest may suck, but that is the silver lining!
wow, SIMS in reno is paying better than that!!
#1 copper 2.20
#2 copper 2.07
#2 ICW 0.63
#3 ICW 0.28
Brass 1.55
6360 0.58
MLC 0.49
Cast 0.54
60% cast 0.17
S.S. 0.43
Motors 0.20
Sealed units 0.11
Ballasts 0.06
That's as of 6/26/15.
0.50 for motors in reno??
wait, corrected. my bad 0.20 for motors
Ok, same here haha. I was going to be buying up all the motors in the city.
$.10 per pound for motors in northeat ms. Hauled in 900 pounds of stainless today @ $.30 per pound. Disappointed best describes it
Got paid .09 for motors last week. Yikes! ! !
I asked at.my.yard yssterday 15 cents for motors and.8 cents for sealed units. Have t check with local sims. But their process takes.near an hour. While at the other place in and out in 10-15 minutes. Time.is money
Unless it was changed OR I was about half asleep (certainly a possibility) I would have swore it said .5 which is .50/lb for brown board....again it could have been me, but I know I looked at it 2x I thought since it was so **** much for brown board...I normally get .10/lb but we will see on this load (granted I am going anyways and have already stripped them of anything easy to get)