Treadmill Breakdown

http://i1332.photobucket.com/albums/...pshtf0hts4.jpg First thing you want to do is fold the treadmill up. http://i1332.photobucket.com/albums/...psd1kqcqal.jpg http://i1332.photobucket.com/albums/...psz4hwgylg.jpg Then when folded down, unscrew the screws on the very back. Then flip the treadmill down again and take off the panel. http://i1332.photobucket.com/albums/...pslquskao9.jpg once that panel is off start unscrewing and unplugging everything. http://i1332.photobucket.com/albums/...pskov8q54z.jpg Then to get the motor out I used 2 wrenches. http://i1332.photobucket.com/albums/...psyyihcv8u.jpg http://i1332.photobucket.com/albums/...ps4oafiq7f.jpg Next the control panel

Undo these 4 bolts to remove the panel.http://i1332.photobucket.com/albums/...pslkg3ldyj.jpg once those are removed, unscrew the boards and get the wire. http://i1332.photobucket.com/albums/...psh6huq5fb.jpg There will also be 4 of these, pry off the stainless steel. http://i1332.photobucket.com/albums/...psja0gsfah.jpg

Next is the gearbox at the time I didn't know what this was but soon decided to throw it in as breakage because of all the grease. I did grab the motor though. http://i1332.photobucket.com/albums/...psxf6em2lv.jpg I cut the windings out of it with a dremel. Next is the heat sink like thing. http://i1332.photobucket.com/albums/...psythqk6as.jpg Not much to it, unscrew the board and unplug the wires.

In the end I hadhttp://i1332.photobucket.com/albums/...psdtgg0ikx.jpg a little silver Mylar, 4 mid grade boards, a chunk of extruded, a chunk of cast http://i1332.photobucket.com/albums/...psmtnnbit4.jpg wire, #2 copper http://i1332.photobucket.com/albums/...pshiprm2i4.jpg motors, 4 pieces of stainless, breakage ( gearbox), and if course all the steel.

http://i1332.photobucket.com/albums/...ps0qpsgmqz.jpg I used these tools http://i1332.photobucket.com/albums/...psu5gyhz2f.jpg flat and Philips screwdrivers, a magnetic parts dish, wire cutters, 2 9/16 wrenches, a hammer, impact gun, and a dremel AS A WARNING, BE CAREFUL LOADING THE MAIN STEEL PART, MY FINGER GOT STUCK IN BETWEEN IT SO BE CAREFUL!