Printable View
Well today I was just throwing some HVAC stuff into the truck when i seen A large motor and a smaller one, I took off the covers, (cast aluminum, a dollar right there) And there is a ton of #2 in there, I just dont want to waste too much of my time getting it out, any ideas?
Take a grinder and cut each side of the copper then some pliers and pull it out doesnt take that long
Alright I will see, Also you know the long kinda plasticy metal things the copper is attached to? does that have any value?
The plastic is worthless just pull it off the copper i think its used to insulate the copper from the steel inside the motors