35 percent nickel
20 percent cobalt
4 percent titanium
4 percent moly
balance crome and iron I can't remember how much of each I think 18 percent crome and balance iron
All I know is its takes about 7 mins to cut through them with the jet torch and a three foot torch would be a joke if you attempted to cut them with it. We cut off about 3400 lbs of them off turbine covers. Cut the steel off of them. I hope this picture shows up if not I will post a link to them.
Well that didn't work uploading it from my computer they seriously need to figure out a way to make this easier but here is the link.
http://www.flickr.com/photos/5958268...in/photostream
Bookmarks