Page 1 of 2 12 LastLast
Results 1 to 20 of 24

question on whats good and whats not.

| Scrap Metal Tips and Advice
  1. #1
    mmasini started this thread.
    SMF Badges of Honor

    Member since
    Apr 2012
    Location
    Bangor Maine
    Posts
    4
    Thanks
    0
    Thanked 0 Times in 0 Posts

    Cool question on whats good and whats not.

    hi guys, there is 'spring clean up' in my area here soon, and i was wondering what items i should be on the look out more. for example. are dryers better than washers, are stoves better than fridges etc etc. i have limited space and i want to get what is more valuable. and i am kinda new at this so any help would be great. i know that some item have more 'hidden' copper than other but im not sure what to keep and what to pass on.

    thanks
    mike



  2. #2
    happyscraper's Avatar
    SMF Badges of Honor


    Member since
    Feb 2012
    Location
    spring hill,fl
    Posts
    2,864
    Thanks
    350
    Thanked 1,371 Times in 847 Posts
    I don't know how much room you have but if were me I would take anything that has scrap value. If you don't have much room maybe e-waste would be better for you. In that case computers ar the most valuable. You could go around and clip the power cords off everything. Washers and dryers will have copper wires if you take the pannle behind the controls, they go down the back all the way to the motor. Pull the motor off, most have al. windings but you can sell the whole motor. Hope this helps a little.

  3. #3
    YardApe's Avatar
    SMF Badges of Honor


    Member since
    Apr 2012
    Location
    MIDWEST
    Posts
    11
    Thanks
    0
    Thanked 12 Times in 7 Posts
    Washers/dryers / stoves will bring the same price.Most buyers will require anything with a refigeration compressor to be removed or evacuated.The compressor from the fridge and the electric motors from the washer/dryer will be worth more.But dont try to remove the compressor unless you are a pro.It has a lot of pressure and can be dangerous.As for "hidden copper" there will be only the insulated copper present in the items you described.....other than the copper present in the electric motors and compressor unless they are aluminum wound.

  4. #4
    SMF Badges of Honor

    Member since
    Apr 2012
    Location
    Fort Edward NY
    Posts
    5
    Thanks
    1
    Thanked 2 Times in 1 Post
    Stoves and fridges bring me .11 cents a pound. Sometimes its not worth the aggravation of cutting all of the copper wires out of everything, but I do. I get .83 cents even for insulated wire. If you have a sheet metal shop in your area, have them make you a "homemade" wire splitter. Piece of sheet metal with a hole drilled-in for cord size, then they can weld a razor blade just right for splitting the wire open when you pull it through. There is a nice demonstration on youtube....Search "homemade wire splitter" -Good Luck!

  5. The Following 2 Users say Thank You for This Post by ripitapart:


  6. #5
    mmasini started this thread.
    SMF Badges of Honor

    Member since
    Apr 2012
    Location
    Bangor Maine
    Posts
    4
    Thanks
    0
    Thanked 0 Times in 0 Posts

    Cool

    great, thanks for the advice guys. i really only have my pick up for space so when i said limited, i wasnt joking. .
    i called the surrounding towns for the spring clean up dates and hope i can hit them up before other people.

  7. #6
    TMoney's Avatar
    SMF Badges of Honor



    Member since
    Mar 2012
    Location
    PA
    Posts
    116
    Thanks
    82
    Thanked 123 Times in 32 Posts
    Quote Originally Posted by mmasini View Post
    hi guys, there is 'spring clean up' in my area here soon, and i was wondering what items i should be on the look out more.
    Thanks for asking the question, I was just thinking about asking the same thing. I'm in the same situation here. The local clean up day is tomorrow, and they never order enough roll offs. They always end up making piles of scrap until they can get the dumpsters switched out. I have seen them let scrappers come in and grab a few items before. I too only have my pickup available, so I wanted to get the most $ per cubic foot.

  8. #7
    Mulden's Avatar
    SMF Badges of Honor


    Member since
    Nov 2011
    Location
    Sheffield, England
    Posts
    93
    Thanks
    20
    Thanked 43 Times in 29 Posts
    In order of value (IMO):

    Freestanding Oven
    Metal Dishwasher
    Washing Machine
    Dryer
    Microwave
    Gas BBQ
    LCD TV
    CRT TV
    Fluorescent Lamp
    Standing Fan
    Aluminium Can

    Hope this helps!

  9. The Following User Says Thank You to Mulden for This Post:


  10. #8
    Dunemaul's Avatar
    SMF Badges of Honor



    Member since
    Nov 2011
    Location
    East Orlando FL
    Posts
    1,064
    Thanks
    157
    Thanked 560 Times in 301 Posts
    I wanna know how a LCD is beating a CRT.
    Born to think, destine to succeed.

  11. The Following User Says Thank You to Dunemaul for This Post:


  12. #9
    Mulden's Avatar
    SMF Badges of Honor


    Member since
    Nov 2011
    Location
    Sheffield, England
    Posts
    93
    Thanks
    20
    Thanked 43 Times in 29 Posts
    Quote Originally Posted by Dunemaul View Post
    I wanna know how a LCD is beating a CRT.
    When I weighed out all the steel and boards in an LCD it totalled at least 20% higher than the copper and ali count ina CRT (although my size average for a CRT is only 20"). Plus there isn't a hulking great lead and glass tube to dispose of.

  13. The Following 4 Users say Thank You for This Post by Mulden:


  14. #10
    TMoney's Avatar
    SMF Badges of Honor



    Member since
    Mar 2012
    Location
    PA
    Posts
    116
    Thanks
    82
    Thanked 123 Times in 32 Posts
    Quote Originally Posted by Mulden View Post
    In order of value (IMO):

    Freestanding Oven
    Metal Dishwasher
    Washing Machine
    Dryer
    Microwave
    Gas BBQ
    LCD TV
    CRT TV
    Fluorescent Lamp
    Standing Fan
    Aluminium Can

    Hope this helps!
    That is exactly what I was looking for. Thanks! I see that refrigerators didn't even make the list. Is this because of the freon hassle? Would the other say that their top ten list contains all the same items? I thought that Air Conditioners and Hot Water heaters were both good too.

  15. #11
    SMF Badges of Honor


    Member since
    Sep 2011
    Posts
    152
    Thanks
    30
    Thanked 47 Times in 29 Posts
    Just about every LCD TV you see curbside that does not have a physically broken screen just needs a few capacitors replaced to get it working again. Its a common problem where the caps on the power supply board bulge or burst and it stops working. Less than 5 dollars worth of parts and a little time spent soldering to replace them and you now have a working TV you can keep for yourself or sell.

  16. The Following 3 Users say Thank You for This Post by G_P:


  17. #12
    SMF Badges of Honor

    Member since
    Aug 2012
    Location
    mileburg pa
    Posts
    255
    Thanks
    3
    Thanked 103 Times in 64 Posts
    also don't forget your wire cutters .lots of vacuums get put out .also cable, sat boxes, laptops, computers. dvd players, lcd monitors
    ac units and dehumidifyers ,screen doors(alum). this are items I find a lot

  18. #13
    MattInTheHat's Avatar
    SMF Badges of Honor


    Member since
    Sep 2012
    Location
    rock hill, sc
    Posts
    1,464
    Thanks
    1,142
    Thanked 1,396 Times in 703 Posts
    stove, washers. dryers. etc take up a lot of room for what they weigh.

  19. #14
    cummins's Avatar
    SMF Badges of Honor


    Member since
    Apr 2013
    Location
    ontario
    Posts
    573
    Thanks
    15
    Thanked 255 Times in 171 Posts
    a picky scrapper is a hungry scrapper, never drive by anything with scrap value, 90% of the time it won't be their on your way back.

  20. The Following User Says Thank You to cummins for This Post:


  21. #15
    99problems's Avatar
    SMF Badges of Honor


    Member since
    Jul 2013
    Location
    Atlanta
    Posts
    72
    Thanks
    6
    Thanked 17 Times in 9 Posts
    Quote Originally Posted by cummins View Post
    a picky scrapper is a hungry scrapper, never drive by anything with scrap value, 90% of the time it won't be their on your way back.
    Im very new to this, and i learned that lesson quickly (very recently)

  22. #16
    Scrapette's Avatar
    SMF Badges of Honor

    Member since
    Oct 2011
    Location
    Kentucky USA
    Posts
    942
    Thanks
    2,392
    Thanked 924 Times in 414 Posts
    A storage space might be worth it if you're looking at a lot of stuff - one with a month to month lease.
    Don't forget to check blinds to see if they are aluminum. Also people often throw out aluminum siding.
    Some older decorative wall hangings are made from brass.
    Per pound e-scrap will probably be your best money if you have to pick as happyscraper said.
    Success consists of going from failure to failure without a loss of enthusiasm...... Churchill

  23. #17
    SMF Badges of Honor

    Member since
    Feb 2013
    Location
    Somewhere near the Beach, NW FL
    Posts
    127
    Thanks
    406
    Thanked 53 Times in 25 Posts
    Quote Originally Posted by Mulden View Post
    In order of value (IMO):

    Freestanding Oven
    Metal Dishwasher
    Washing Machine
    Dryer
    Microwave
    Gas BBQ
    LCD TV
    CRT TV
    Fluorescent Lamp
    Standing Fan
    Aluminium Can

    Hope this helps!
    You forget the house fridge!

  24. #18
    SMF Badges of Honor

    Member since
    Feb 2013
    Location
    Somewhere near the Beach, NW FL
    Posts
    127
    Thanks
    406
    Thanked 53 Times in 25 Posts
    Quote Originally Posted by G_P View Post
    Just about every LCD TV you see curbside that does not have a physically broken screen just needs a few capacitors replaced to get it working again. Its a common problem where the caps on the power supply board bulge or burst and it stops working. Less than 5 dollars worth of parts and a little time spent soldering to replace them and you now have a working TV you can keep for yourself or sell.
    CRT TV's are so hard to sell unless they are big screen......

  25. #19
    TheRecycler's Avatar
    SMF Badges of Honor


    Member since
    Jan 2013
    Location
    Ithaca, NY
    Posts
    616
    Thanks
    31
    Thanked 413 Times in 199 Posts
    Quote Originally Posted by mmasini View Post
    hi guys, there is 'spring clean up' in my area here soon, and i was wondering what items i should be on the look out more. for example. are dryers better than washers, are stoves better than fridges etc etc. i have limited space and i want to get what is more valuable. and i am kinda new at this so any help would be great. i know that some item have more 'hidden' copper than other but im not sure what to keep and what to pass on.

    thanks
    mike
    Are you crazy, take it all, washer, dryer, stove fridge, etc.
    Your Trash-My Cash
    Yours Truly, TheRecycler:
    RecycleReuseItAll@Facebook.com

  26. The Following User Says Thank You to TheRecycler for This Post:


  27. #20
    FLimits's Avatar
    SMF Badges of Honor

    Member since
    Jan 2014
    Location
    NY
    Posts
    459
    Thanks
    654
    Thanked 598 Times in 271 Posts
    What are these "spring cleanup" and "local cleanup" events? (I live in a city, so we don't have whatever that is.)
    The only thing like that I've ever heard of is where people volunteer to go out and pick up litter (of *all* kinds, not just valuable stuff) that has accumulated in the area.


  28. Similar threads on the Scrap Metal Forum

    1. so whats this then
      By nivlac in forum Scrap Metal Questions and Answers
      Replies: 5
      Last Post: 04-02-2012, 02:55 PM
    2. treasure, whats this ?
      By EcoSafe in forum A Day in the Life of a Scrapper
      Replies: 8
      Last Post: 01-16-2012, 02:27 AM
    3. Whats up from florida
      By badewolf in forum Introduce yourself
      Replies: 4
      Last Post: 01-16-2012, 01:40 AM
    4. Motors? Whats best?
      By skipRAT in forum Dismantling, Breaking Down & Maximizing Scrap
      Replies: 13
      Last Post: 12-08-2011, 04:43 PM
    5. whats up yall from NC
      By YoungScrapper in forum Introduce yourself
      Replies: 4
      Last Post: 06-10-2011, 03:41 AM

Page 1 of 2 12 LastLast

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

 
Browse the Most Recent Threads
On SMF In THIS CATEGORY.





OR

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

The Scrap Metal Forum

    The Scrap Metal Forum is the #1 scrap metal recycling community in the world. Here we talk about the scrap metal business, making money, where we connect with other scrappers, scrap yards and more.

SMF on Facebook and Twitter

Twitter Facebook