|
Don't feel bad, I never have either. Just never crossed my mind. We were using a Dremel and the speed kept slowing down, I think the brushes are going out already. Their just not made for that type of (long term) heavy duty cutting. The angle grinder is better suited for that.Well, I've been a member since 7-19-11 and haven't introduced myself at the "introduction" page either.
P & M Recycling - Specializing in E-Waste Recycling.
If you enjoy your freedom, thank a vet.
Thornton Scrapper
|
Cut the windings with wire cutters or a hack saw and then pry in out with a big screwdriver on to uncut side. cut the string off first. it looks like its aluminum wire to me..........
Experienced Scrapper
I use an angle grinder with a cut off to take off the loops on one side then try to pry the rest out with a big scrwdriver. If they don't pry out just tap 'em out with a punch where you cut them off. I've tried using a sawzall but it just make a mess if the loops aren't taped or tied to keep it in one piece as you cut it.
Eat. Sleep. Scrap.
There are currently 1 users browsing this thread. (0 members and 1 guests)
|
Browse the Most Recent Threads
On SMF In THIS CATEGORY. 
OR 
|
Posting Permissions
Register To Reply
Bookmarks