Page 1 of 3 123 LastLast
Results 1 to 20 of 47

Finally a set date

| A Day in the Life of a Scrapper
  1. #1
    pcscrapper started this thread.
    pcscrapper's Avatar
    SMF Badges of Honor

    Member since
    Aug 2012
    Location
    623 s Lyon st Suite 200 Sioux Falls SD 57104
    Posts
    657
    Thanks
    576
    Thanked 481 Times in 226 Posts

    Finally a set date

    Hey folks there are a few on here that was curious about the status of whats going on, figure I would just send out a little not here.

    ON Oct 10th, I'll be having a very very risky surgery, This surgery will help release the preasure off my heart and allow my lung to fully expand for once in its life. Being an active person, been a difficult journey.. Not being able to do as much, I had surgery done in 2010 where the surgeon had removed the sternum without informing us and pulling My ribs closer together, why the orignal surgery, I had the PECTUS EVACTUM basically if you do a goodle search for Nuss Procedure You'll see what a pectus disease is, By removing My sternum and pulling my ribs in closer as pushed my heart into a non formal shape and also allowing the diaphram to slip over the ribs instead of sliding back n forth under the rib which cause alot of preasure and very very limited breathing capacity.

    So whats going to happen, since I had my chest gutted open once, I'm at risk for adhesion, So now my heart is stuck to the wall of My chest. with a very experince surgeon We've selected, he going to prepare to cut My midline section open and pull my ribs upward and crack a few of them, during this procedure is the most critical and dangerous part when sliding the saw upward to my collar bone, he will not be able to see where My heart is located until its too late. They are going to pry the heart down and away from the blade as they attempt to saw thru the mid line of my chest to allow them to again open the chest and snap a few ribs so when they heal they will heal in a new shape, once they have it open and cleared I've a very experince Pediatric surgeon that is going to put in place a fake sternum and widen my chest just a tad bit more to allow the heart to feeling open and close without anymore restriction and also allow Me to take in My first FULL Breath in 47 years. he would then secure that piece in place and close me up. the hospital stay is approx 10 to 12 days, and recovery from this procedure will be approx 2 months.



    I asked that all My scrapper fans Keep Me in there prayers when I undergo this very risky surgery, I keep My head clear and always thinking positive.

    Thanks for all your in advance support and prayer.

    Larry
    Please Add Us On FaceBook, PC SCRAPPER Sioux Falls SD
    also our Prices are listed here http://pcscrapperS.com
    PC Scrappers LLC
    623 S LYON ST SUUTE 200Sioux Falls, SD 57104
    1-605-271-2616

  2. The Following 5 Users say Thank You for This Post by pcscrapper:



  3. #2
    SMF Badges of Honor

    Member since
    Jul 2011
    Posts
    961
    Thanks
    609
    Thanked 1,399 Times in 431 Posts
    Thoughts and prayers will be with you Larry.
    Specializing in Maximum value for mixed precious metal printed circuit boards and electronics

    Check out our pricing and read some of our RAVING reviews: http://www.scrapmetalforum.com/scrap...tal-scrap.html
    QUESTIONS? Email us: info@CashForComputerScrap.com
    or Chat with us: www.CashForComputerScrap.com

  4. The Following 2 Users say Thank You for This Post by Ewasted:


  5. #3
    BroJer's Avatar
    SMF Badges of Honor


    Member since
    Feb 2012
    Location
    Phoenix-West Valley
    Posts
    1,004
    Thanks
    3,210
    Thanked 1,610 Times in 641 Posts
    Will for sure keep you and the medical team in our prayers!! +++Bro

  6. The Following User Says Thank You to BroJer for This Post:


  7. #4
    jord0690's Avatar
    SMF Badges of Honor


    Member since
    Sep 2012
    Location
    Barrie
    Posts
    1,180
    Thanks
    27
    Thanked 716 Times in 440 Posts
    Hope all goes well man! I'll be thinkin of ya. Let us know when you're back!
    If I didn't have bad luck, I'd have no luck at all...

    GC Metal Recycling & Recovery
    Barrie, Ontario.

  8. The Following User Says Thank You to jord0690 for This Post:


  9. #5
    SMF Badges of Honor

    Member since
    Feb 2012
    Location
    Osage,IA
    Posts
    133
    Thanks
    54
    Thanked 65 Times in 40 Posts

    Finally a set date

    Larry you'll be in my thoughts and prayers. Think positive put your trust in god he will see you thru this need to ever bs pm me anytime best wishes to you and your family.

  10. The Following User Says Thank You to IAscrapper for This Post:


  11. #6
    KzScrapper's Avatar
    SMF Badges of Honor


    Member since
    Apr 2011
    Location
    Denver Metro, CO
    Posts
    4,841
    Thanks
    7,019
    Thanked 5,792 Times in 2,417 Posts
    Godspeed in your recovery.
    Recyclable Material Merchant Wholesaler
    Certified Zip-Tie Mechanic
    "Give them enough so they can do something with it, but not too much that they won't do nothing."

  12. The Following User Says Thank You to KzScrapper for This Post:


  13. #7
    1956's Avatar
    SMF Badges of Honor

    Member since
    Jul 2012
    Location
    Fort lauderdale FL The Venice of The USA
    Posts
    642
    Thanks
    399
    Thanked 1,276 Times in 348 Posts
    I will say a prayer for your speedy recovery

  14. The Following User Says Thank You to 1956 for This Post:


  15. #8
    newattitude's Avatar
    SMF Badges of Honor


    Member since
    Jun 2011
    Location
    Hinckley Ohio, home of the buzzards
    Posts
    2,163
    Thanks
    1,431
    Thanked 2,497 Times in 904 Posts
    Larry, I will be thinking of you and I will say a prayer for you . maybe a family member can give us an update .
    Scrapper, Scrap Yard Worker, Horse farm worker, Cooler Puller and just plain ''tired''

  16. The Following User Says Thank You to newattitude for This Post:


  17. #9
    Ohio Scrapper's Avatar
    SMF Badges of Honor


    Member since
    Jul 2011
    Location
    NW Ohio
    Posts
    336
    Thanks
    467
    Thanked 298 Times in 160 Posts
    You'll be in my thoughts and prayers as well, Larry.

  18. The Following User Says Thank You to Ohio Scrapper for This Post:


  19. #10
    tski72's Avatar
    SMF Badges of Honor

    Member since
    Feb 2012
    Location
    Crystal Lake, IL
    Posts
    399
    Thanks
    283
    Thanked 361 Times in 200 Posts

    Finally a set date

    Thoughts and prayers go out to you for a successful surgery and a full and speedy recovery, also may you be blessed with your family, that they will provide all the support that you will need during your recovery. God will be watching over you. God bless
    Cleaning up the e-waste one company at a time

  20. The Following User Says Thank You to tski72 for This Post:


  21. #11
    BRASSCATCHER's Avatar
    SMF Badges of Honor


    Member since
    Feb 2012
    Posts
    2,476
    Thanks
    3,436
    Thanked 3,965 Times in 1,383 Posts
    Good luck and hopes for a speedy recovery.
    I won't be wronged. I won't be insulted. I won't be laid a-hand on. I don't do these things to other people, and I require the same from them.” John Wayne-- The Shootist

    NEWBS READ THIS THREAD ABOUT REFINING!!!!
    http://www.scrapmetalforum.com/off-t...ning-read.html

  22. The Following User Says Thank You to BRASSCATCHER for This Post:


  23. #12
    SMF Badges of Honor


    Member since
    Apr 2013
    Location
    MISSISSIPPI
    Posts
    172
    Thanks
    97
    Thanked 175 Times in 76 Posts
    May God walk with you during this time. His grace be with you.
    You can make money 2 ways.
    1 - Do what others won't.
    2 - Do what others can't.

  24. The Following User Says Thank You to VERYOLDGUY for This Post:


  25. #13
    SMF Badges of Honor


    Member since
    Apr 2013
    Location
    Chicago Suburbs
    Posts
    18
    Thanks
    0
    Thanked 11 Times in 9 Posts
    God be with you.

    Bossandy

  26. The Following User Says Thank You to Bossandy for This Post:


  27. #14
    volvoscrapper's Avatar
    SMF Badges of Honor


    Member since
    Aug 2012
    Location
    New Jersey
    Posts
    209
    Thanks
    289
    Thanked 218 Times in 111 Posts
    prayers to guide the doctors and for a rapid recovery!

  28. The Following User Says Thank You to volvoscrapper for This Post:


  29. #15
    SMF Badges of Honor


    Member since
    Nov 2012
    Location
    South East Arkansas
    Posts
    282
    Thanks
    100
    Thanked 157 Times in 79 Posts
    We'll be praying for you/

  30. The Following 2 Users say Thank You for This Post by Arkansaw:


  31. #16
    pcscrapper started this thread.
    pcscrapper's Avatar
    SMF Badges of Honor

    Member since
    Aug 2012
    Location
    623 s Lyon st Suite 200 Sioux Falls SD 57104
    Posts
    657
    Thanks
    576
    Thanked 481 Times in 226 Posts
    I truly want to say Thank You Scrappers for the Kind words and prayers ... I've faith In God as He is the creator of this world. and I belive in all My Heart He will be next to me with his hands upon the surgeon.

    Thanks for all the kind words in advance.

  32. The Following 2 Users say Thank You for This Post by pcscrapper:


  33. #17
    SMF Badges of Honor



    Member since
    Feb 2012
    Location
    OK
    Posts
    5,728
    Thanks
    6,814
    Thanked 3,464 Times in 1,989 Posts
    best wishes and good luck pcs!

  34. The Following User Says Thank You to Bear for This Post:


  35. #18
    parrothead's Avatar
    SMF Badges of Honor


    Member since
    Jan 2011
    Location
    Treasure Coast, FL
    Posts
    2,416
    Thanks
    667
    Thanked 2,067 Times in 953 Posts
    Best wishes on this buddy. Hope to see you up and running soon.
    "64K should be enough for anybody." - Bill Gates 1981
    http://www.treasurecoastelectronicrecycling.com/

  36. The Following User Says Thank You to parrothead for This Post:


  37. #19
    SMF Badges of Honor

    Member since
    Jul 2013
    Location
    Ohio
    Posts
    162
    Thanks
    54
    Thanked 221 Times in 89 Posts
    I'll be praying for you. Take advantage of the time you'll have recovering to think and read - and pray, as I'm sure you will. Look forward to seeing you back on here when you're able.

  38. The Following User Says Thank You to foobar for This Post:


  39. #20
    Patriot76's Avatar
    SMF Badges of Honor


    Member since
    Dec 2012
    Location
    Buffalo Commons
    Posts
    2,949
    Thanks
    10,591
    Thanked 7,220 Times in 2,256 Posts
    My thoughts and prayers are with you. Good luck to you and your family.

  40. The Following User Says Thank You to Patriot76 for This Post:



  41. Similar threads on the Scrap Metal Forum

    1. Indiana | For Sale - Anyone Need a Set of Steel 6 lug 15" Trailer Rims? Set of 4
      By sledge in forum Scrappers Classifieds
      Replies: 2
      Last Post: 03-16-2013, 10:40 AM
    2. Replies: 0
      Last Post: 03-30-2012, 05:01 AM
    3. Feeling a little better so heres an up date.
      By EcoSafe in forum Off Topic Discussions
      Replies: 13
      Last Post: 03-18-2012, 03:16 PM
    4. anurism up date:
      By EcoSafe in forum Off Topic Discussions
      Replies: 29
      Last Post: 03-01-2012, 06:30 PM

Page 1 of 3 123 LastLast

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

 
Browse the Most Recent Threads
On SMF In THIS CATEGORY.





OR

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

The Scrap Metal Forum

    The Scrap Metal Forum is the #1 scrap metal recycling community in the world. Here we talk about the scrap metal business, making money, where we connect with other scrappers, scrap yards and more.

SMF on Facebook and Twitter

Twitter Facebook